Skip to main content

Submit a request

JGMaker English
Tech Support
Artist D & Artist D Pro

Articles in this section

When you level bed , what tips do you pay attention to for Artist-D/pro?
How to take part the Extruder for Artist-D /Pro ?
Artist-D pro: An Example of X Y Z Axis Offset Calibration
How to adjust the Y-axis belt tension for Artist-D/pro
How to adjust X-axis belt tension for Artist-D/pro ?
How to solve the hotbed shaking problem for Artist-D /pro?
Artist-D/pro: what to do when you meet with "Filament detection switch is not pressed"
How to replace the Z limit switch for Artist-D？
What to do when the z-axis not moving for Artist-D /pro ?
How to change the new structure for Extruder 2 ?

See more

How to change the new structure for Extruder 2 ?

Support

May 13, 2021 10:23
Updated

Was this article helpful?

3 out of 6 found this helpful

Have more questions? Submit a request

Related articles

Artist-D/pro: what to do when you meet with "Filament detection switch is not pressed"
How to solve the problem that two extruders crashing when printing Mirrored /Duplicate model?
How to take part the Extruder for Artist-D /Pro ?
How to solve the Z-axis secondary limit failure for Artist-D pro ?
How to solve the issue that the Artist-D /Pro can't read SD card or read SD card not working ?

Comments

0 comments

Please sign in to leave a comment.

JGMaker English

Powered by Zendesk